--- title: "show ipv6_ospf" canonical: "https://docs.infoblox.com/space/nios86/35759190/show%20ipv6_ospf" format: markdown --- The `show`` ``ipv6_ospf`` `command displays configuration and statistical information about the OSPFv3 protocol (if any) running on the NIOS appliance. For information on changing OSPF log settings, see [*set ipv6_ospf*](https://infoblox-docs.atlassian.net/wiki/spaces/nios86/pages/35761032). # Syntax `show ipv6_ospf {route | interface | database | neighbor | configuration}` | **Argument ** | **Description** | | --- | --- | | `route` | Displays the OSPF routing table, as determined by the most recent SPF calculation. | | `interface` | Displays the state and configuration on all interfaces configured with OSPF. | | `database` | Displays all OSPF database information. | | `neighbor` | Displays the OSPF neighbor information. | | `configuration` | Displays the running OSPF configuration file. | # Examples `Infoblox > ``show ipv6_ospf` `OSPFv3 Routing Process (0) with Router-ID 10.34.1.179` ` Running 11d03:14:41` ` Number of AS scoped LSAs is 2` ` Number of areas in this router is 1` ` Area 0.0.0.61` `    Number of Area scoped LSAs is 4` `    Interface attached to this area: eth1` `Infoblox > ``show ipv6_ospf interface` `eth1 is up, type BROADCAST` ` Interface ID: 11` ` Internet Address:` `    inet : 10.34.1.179/29` `    inet6: 2001:db8:a22:1b0::3/64` `    inet6: fe80::230:48ff:febc:9503/64` ` Instance ID 0, Interface MTU 1500 (autodetect: 1500)` ` MTU mismatch detection: enabled` ` Area ID 0.0.0.61, Cost 1` ` State BDR, Transmit Delay 1 sec, Priority 1` ` Timer intervals configured:` `  Hello 10, Dead 40, Retransmit 5` ` DR: 255.1.1.1 BDR: 10.34.1.179` ` Number of I/F scoped LSAs is 2` `  0 Pending LSAs for LSUpdate in Time 00:00:00 [thread off]` `  0 Pending LSAs for LSAck in Time 00:00:00 [thread off]` `eth2 is down, type BROADCAST`