set docker_bridge command resets the IP address of the current Docker bridge to the IP address that you specify. You can view the IP address of the current Docker bridge by running the
show docker_bridge command.
This command has no arguments.
Infoblox > set docker_bridge
Enter Bridge Gateway/CIDR: 172.17.0.1/16
New Docker Bridge settings:
Bridge Gateway/CIDR: 172.17.0.1/16
Current Docker Bridge settings:
Bridge Gateway/CIDR: 172.16.0.1/16
WARNING: This operation will restart the system to reset the current docker bridge settings.
Do you want to proceed? (y or n):y
Docker bridge settings have been updated.
System will be restarted.
- The warning message to restart the system is displayed only if the Enable Recursive Queries Forwarding to BloxOne Threat Defense Cloud checkbox is selected. For information about this checkbox, see Forwarding Recursive Queries to BloxOne Threat Defense Cloud.
- Infoblox recommends that you run the
set docker_bridgecommand only on non-routable IP addresses.
- Infoblox does not recommend that you run the
set docker_bridgecommand on a passive HA node
This page has no comments.